| The coating is single pack system which gives easy to use & suitable for various climates and reduces costs of rejection by not having risk of jellifying process. The water based Aquazinc™ coatings are normally non flammable, Easy water cleanup, Low Odor, Environmental friendly and low Curing temperature compares to other products around 200 deg c. This coating has a ability to recoat and better adhesion with different substrate. |
 |
|
Zinc - Al Flake Structure |
 |
|
Replacement To Zinc Plating With Aquazinc Water Base Zinc Flake Coating |
 |
|
Aquazinc Coated Bolts |
|
| The Aquazinc is made by -Al. flake, water borne one coat system, Silver grey in appearance. This coating is integrated with lubricants and do not need of additional top coat to adjust the co-efficient of friction values for threaded hardware parts and Fasteners. |
| Single coating system applied by 2 times or as required by dip spin coating and one coat by Spray. It is economical application due to no change in coating chemical for 2nd coating cycle in Dip-Spin application. The single coat water based coating is best suitable for Replacing of Zinc Plating! |
| Environment Protection by Aquazinc™ Coating |
| There are no hazardous and declarable substances in Aquazinc™ coating, thus it is friendlier with environment. The Polymet coatings are water based therefore I is low HAP (hazardous Air Pollution), Low VOC (Volatile Organic Content). The coating meets ELV, WEE and ROHS norm guidelines for not using hazardous and declarable substances. |
| Application for Aquazinc™ Coating |
| Aquazinc™ products can be applied with Non Electrolytically applied Dip Spin coating techniques for mass produced hardware parts and by spray application with or without electrostatic for larger metal parts |
| Main Characteristics of Aquazinc™ Coating |
| The first and important characteristic of Aquazinc™ coating is higher corrosion protection in comparison with electrolytically deposited zinc or zinc alloys. With uniform application of coating layer by advanced application techniques, depends up on pre-treatment and geometry of component; over 240 hours SST can be achieved and the coating is suitable for spring steel and high strength steel parts. |
| |
| No of Coats |
Application Method |
Thickness |
Salt Spray
(ASTM -B117) |
Kestenritch Test
(DIN 50018-2.0L) |
| 3xAquazinc |
Dip Spin |
>10-15 Microns |
>480 Hours* |
15-30 Cycles** |
| 1xAquazinc |
Spray |
>10-15 Microns |
>480 Hours* |
15-30 Cycles** |
| 2xAquazinc |
Spray |
>12-15 Microns |
>720 Hours * |
15-30 Cycles* |
| 2xAquazinc+ |
Dip Spin |
>20 microns |
>720 Hours * |
15-30 Cycles* |
| 2xSeal Black/Green/Red/Blue/White etc. |
|
| *The SST Hours considered with or less than 5% red rust on component and these are indicative results for reference only. |
| **Results may vary component to component basic; these are indicative properties for reference only. |
| |
